It is important to prepare museum buildings and collections for winter closing in a well planned and organized manner.
Some insurance policies become ineffective if the building insured is not occupied or regularly inspected. It is therefore important to inform the insurance company of the closing date and to confirm that the coverage is adequate.
Inform the fire department of the museum closing and activate the alarm system.
Request that local police check the building daily. If the museum has a burglar alarm system, connect it.
To discourage prowlers, use a photocell or a timer to illuminate selected lights. Inexpensive movement detectors can be purchased and connected to the burglar alarm.
Cover windows with well constructed panels fastened from the inside. Haphazard boarding up, and poorly maintained buildings appear deserted and attract vandals.
If large windows are not shuttered or boarded, masking tape may be applied to the panes to discourage birds from flying into them.
Ensure that eavestroughs and downspouts are securely attached and cleared of debris, which can cause ice dams, forcing water up under the roof shingles. A plumber's snake is handy for cleaning downspouts. Better still, mesh guard laid over eavestroughs will eliminate this annual cleaning task. Ideally, gutters and downspouts should be run in a straight line to prevent accumulation of debris and pockets of water. At the ground level, downspouts should carry water away from the foundation.
Ensure that lightning rods are properly grounded.
Clear roof and wall vents.
Check the roof for loose, cracked, bulging, curled, worn or missing shingles and have them replaced. This check can be done from the ground with the aid of binoculars.
Check the roof flashing for leaks.
Inspect trees near the building. Remove branches not strong enough to carry a load of snow without breaking and damaging the building.
Check the outside of the building, securing anything that could blow around in high winds.
Ensure that all possible access holes, such as vents and windows, are covered with wire mesh. Wire mesh will also prevent rodents from gnawing through wooden sills or climbing through vents. Mothballs placed in strategic locations are reputed to act as a temporary deterrent but are not reliable over the long term.
Bait and place mousetraps, recording their location. A new type of mousetrap, referred to as a glue board, uses a sticky adhesive surface to trap the rodent.
Use of rodent poisons in a museum can lead to death of rodents in inaccessible places, causing odor and attracting insects.
Bats can be discouraged by keeping a strong incandescent bulb turned on at all times. Exercise extreme caution when exposed to dust from bat dung, as it is a host for histoplasmosis, a serious health hazard.
To discourage rodents, remove anything that might attract them. Foodstuffs are likely to be removed before a closing, but remember that materials such as soap, candles, and sponge also attract rodents.
Fill cracks in the foundation with cement and use metal collars to cover seams where waterpipes run through floors and outside walls.
Trim branches that are close to the building in order to prevent squirrels from jumping onto the building and finding their way in through the eaves.
To discourage birds from nesting in unused chimneys, cover all stovepipes with tight metal caps: a two-pound coffee tin works well for stovepipes.
Inspect collections thoroughly for signs of insect infestation. Re-inspect them when the museum opens again. Use of mothballs, moth flakes and moth crystals (naphthalene, paradichlorobenzene) or insect strips (dichlorvos) cannot be generally recommended for protection of museum artifacts.
Fuller information on pest control can be obtained from CCI.
In areas where temperature falls below 0oC certain precaution must be taken.
Plumbing
When water and heat are turned off:
When water remains on:
Some seasonal museums open in winter for special occasions. For the safety of the collections and the building, it is recommended that sudden and drastic changes in heat be avoided, as this causes the relative humidity (RH) to fluctuate rapidly and drastically. If a building must be heated up, it should be done gradually over two or three days. A comparable cool-down period is also recommended.
Woodstoves, which may add warmth and charm to special occasions, can be a serious fire hazard. The local fire marshal can be asked to inspect them for problems with installation or safety. Well-seasoned firewood and maintenance of a regular cleaning schedule for stovepipes and flues will minimize build-up of creosote.
In some historic buildings stained wallpaper, cracked plaster, and other signs of ageing are left untouched to lend to a building's historic integrity.
In such cases, carefully document existing damage so that staff can detect additional deterioration. A sketched elevation is useful for this purpose.
Long periods of very cold weather, in conjunction with structural problems, can damage foundations. This can result in separation of the building from the foundation, and caving in of parts of the foundation.
Basements of unheated buildings can be economically kept at a temperature above freezing with the use of electric baseboard heaters. If the basement is unheated and shows signs of excessive moisture, a portable dehumidifier can be used. If the unit is advertised as the non-freezing type, it should be noted that ambient temperatures in excess of 18oC are necessary for efficient operation.
Moisture problems can occur in heated basements as well. Two common structural flaws that can cause such problems as:
If the building has a sump pump, check to ensure that it is in good working order.
Leaving a museum building unheated will not threaten the stability of collections. In fact, it will eliminate a major source of dirt, as most heating systems also generate incomplete combustion products and circulate dust. Damage, by sub-zero temperatures, to materials in collections is rare, with the possible exception of oil or acrylic paintings, which have been known to crack at low temperatures. What must be avoided is a sudden drop in temperature, which can produce high RH and condensation.
New buildings that are well sealed, with humidistatic control, should maintain a constant RH at energysaving low temperatures.
Materials that require a more constant RH can be kept in a micro-environment, using silica gel as described in CCI Technical Bulletin 10, Silica Gel.
One of the first places where condensation occurs is the inside face of exterior walls. It is therefore advisable to remove all objects hanging on, and all furniture and objects positioned against or near, exterior walls. Observe correct handling methods when doing so.
Enclosed spaces such as cupboards and wardrobes have a natural buffering capacity, which helps reduce sudden changes in RH. On the other hand, moist air can condense when trapped in such environments.
When they are sitting on cold floors, wardrobes, bureaus and trunks can also trap moisture, due to rising damp. For this reason, it is advisable to raise them on blocks.
The most popular coverings for furniture are polyethylene or cotton. Cotton can be used inside polyethylene to provide a buffer against condensation.
It is preferable to keep objects in the dark to prevent damage caused by visible and ultraviolet light. If windows cannot be shuttered or boarded up, shades or drapes can be closed, if there are any. However, if these window coverings are original accessioned items, they should be removed so that they will not be damaged by the sun, and replaced by drapes that are not part of the collection.
If the museum is in an area where there is danger of flooding, raise furniture off the floor on blocks. Roll up and store rugs as described in CCI Note no. 13/3, Rolled Storage for Textiles.
The problem of snow and ice can be simplified by their immediate clearance; prevent build-up.
Snow-blowers and blade-type removal equipment will chip and scrape historic materials such as cobblestone, brick, and stone pavement.
The practice of using salt can initiate corrosive action on brick, concrete, and metal. A mixture of crushed limestone and urea powder, which helps to keep walkways clear but does not cause efflorescence, is available commercially.
When locking up the building, ensure that switches in the panel box for operating electrical equipment (heat- wraps, photo-cell timers, etc.) are left in the "on" position.
Once a policy on closing procedures for the museum has been established, duties in preparation for closing should be assigned to staff, and contingency plans drawn up to deal with emergencies.
In addition, a schedule of inspection and maintenance visits should be drawn up and strictly adhered to throughout the duration of the closure (Figure 1).
Anti-skid urea and calcium carbonate sand:
Non-freezing dehumidifer:
Water alert alarm:
Heat-wrap:
Photo-cell on timer:
Movement detectors:
![]()
by Mary Peever Ethnology Laboratory
![]()
Copies are also available in French.
Texte également publié en version française.
© Communication Canada, 1988
Cat. No.: NM 95-57/1-3-1988E
ISSN 0714-6221
December 1988
